The SSC35 is listed as a 35 t energy storage carrier. Its brochure dimensions are 6730 mm long, 5300 mm wide and 5500 mm high, with a listed secondary lifting height of 1500 mm. The lifting device is listed at 3300 mm wide and 1500 mm high; these measurements do not establish compatibility with every cabinet.
The photograph is the SSC35 illustration from the supplied brochure, PDF page 2.
SSC35 brochure specifications
| Parameter | Brochure reference |
|---|---|
| Brochure-listed lifting capacity | 35 t |
| Overall length × width × height | 6730 × 5300 × 5500 mm |
| Secondary lifting height | 1500 mm |
| Minimum ground clearance | 200 mm |
| Lifting-device width | 3300 mm |
| Lifting-device height | 1500 mm |
Open the original Ruiding straddle carrier brochure (PDF page 2), printed page 02. The supplied manufacturer catalogue describes brochure versions; the current offered configuration is confirmed in a project proposal.
Start with the cabinet and its approved lifting method
A completed energy storage cabinet may need a supporting frame or specific lifting points. Send its finished gross mass, centre of gravity and a dimensioned drawing. Identify whether the unit travels directly, on a skid or inside a dedicated transport fixture. Count the lifting attachment and any fixture in the load assessment.
The lifting-device width is a separate dimension from the carrier’s overall width. The supplied table does not give an inner-frame width for SSC35. Ask for a configuration drawing that shows the opening, cabinet outline, attachment and clearances throughout pick-up, travel and placement.
If the project involves a full energy storage container rather than a cabinet, compare the container-carrier family using the approved lifting interface. An equal 35 t capacity does not make SSC35 and HKY3532A interchangeable.
Compare the relevant model differences
On a small screen, swipe the table to compare all columns.
| Model | Model details | Listed dimensions / capacity | Selection difference |
|---|---|---|---|
| SSC35 | SSC35 | 6730 × 5300 × 5500 mm | Dedicated lifting-device dimensions listed |
| HKY3532A | HKY3532A | 7100 × 5100 × 6050 mm | Automatic spreader; 3200 mm inner width listed |
Information needed for a configuration review
- Cabinet drawings, mass and centre of gravity, including transport fixtures.
- Cabinet supplier’s approved lifting and support instructions.
- Pick-up and placement heights; whether a skid remains with the cabinet.
- Doors, workshop exits, floor structure and outdoor transfer route.
Use the equipment RFQ checklist to define scope, destination and acceptance requirements. Catalogue dimensions and ratings are reference data; final working clearances and permitted operating conditions belong in the agreed configuration.
Questions buyers ask
Is 3300 mm the SSC35 inner-frame width?
No. The source identifies 3300 mm as the lifting-device width. The inner opening and working clearances require a configuration drawing.
Does the 35 t rating confirm suitability for my cabinet?
Capacity is one input. Geometry, lifting points, mass distribution, fixtures and operating conditions must also be reviewed.
Can SSC35 handle a BESS container?
Describe the container and its approved lifting arrangement. This cabinet-focused reference does not establish container compatibility.
Request a SSC35 configuration review
Share your maximum load, load drawing, lifting interface, route and operating cycle. Mention SSC35 so the proposal can explain any changes from the brochure-listed version. Send your project requirements.
